Deep Soil Mixing

Deep Soil MixingDeep soil mixing (DSM) is a method in which the soil is mechanically mixed with adhesive binders to increase the strength and bearing capacity of under laying soil to the desired depth. Depending on the soil and water table situation the wet or dry methods are applicable.

Geotechnical Design and Solution Ground Improvement Deep Foundation Earth Retention Grouting Technology Injection System Excavation and Stablization Seepage Control Slope Stabilisation Rapid Impact Compaction Deep Soil Mixing Micropile Shotcrete Anchor and Soil Nail Diaphragm Wall Secant Piles Wall Deep Dynamic Compaction Rock fall and avalanche Barrier Sheet pile wall

Technologies

Soil Anchorage

Soil Anchorage

Soil anchorage is an active method for stabilizing inclined lands and excavations. In this method soil wall is drilled up to 20 cm and to enough depth, then preassemble steel reinforcement is placed in the drilled hole and the cement bass grout is injected in the hole. Then it is activated by prestressing hydraulic jacks to stabilize the excavation and incline lands.

Sheet Pile Walls

Sheet Pile Walls

Sheet pile walls are usually installed to support temporarily or permanently the excavations in unstable soils. In large depth the sheet piles are usually supported from lateral movements by anchorage or reciprocal supports.

Top-Down Construction Method

Top-Down Construction Method

Top-down method is a rapid method which enables builders to construct the substructure and superstructure simultaneously. Likewise it is used as an excavation stabilization method in cases where you can’t or you are not allowed to use the other geotechnical methods such as soil nailing and soil anchorage.